Extron electronics DTP2 T/R 211, User Manual

Page: 13 / 43

DTP2 T/R 211 • Installation and Operation 5
Installation and Operation
This section describes the installation and the operation of the DTP2 211 transmitter and
receiver, including:
•
Installation Overview
• Connections
• Operations
Installation Overview
To install and set up the DTP2 211 transmitter and receiver:
1. Turn off all equipment and disconnect it from the power source.
2. Mount the transmitter and receiver (optional) on a rack shelf or furniture (see
Mounting the Transmitter or Receiver on page 30).
3. Connect an HDMI input source to the DTP2 T 211 input (see figure 2 ,
C
on
page 6).
4. Connect an HDMI output device to the DTP2 R 211 HDMI output (see figure 3 ,
D
page 8).
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
port to reduce stress on the HDMI connectors and prevent signal loss due to
loose cable connections (see
Securing the HDMI Connector on page 10).
5. Connect the transmitter DTP2 Out RJ-45 port (see figure 2,
D
) to the receiver
DTP2 In RJ‑45 port (see figure 3 ,
C
) using a Twisted Pair Cable.
6. Connect an unbalanced stereo audio source to the 3.5 mm mini stereo input on
the DTP2 T 211 (see figure 2 ,
B
) for an analog audio input.
7. Connect a balanced or unbalanced stereo or mono audio device to the
DTP2 R 211 via the Audio captive screw output (see figure 3 ,
F
).
8. Set the Audio configuration toggle switch (see figure 3 ,
E
) on the DTP2 R 211
to the UP position to de‑embed digital audio from the HDMI signal and output it to the
captive screw output for analog audio output. Set the Audio configuration toggle
switch to the DOWN position for the analog input from the TRS audio port on the Tx unit
to be transported simultaneously with the digital embedded HDMI audio and output on
the captive screw output (see
figure 3 ,
F
).
9. Connect a serial RS-232 signal, a modulated IR signal, or both into this 3.5 mm,
5‑pole captive screw Over DTP port for bidirectional RS‑232 and IR communication
(see
figure 2 ,
E
on the transmitter and figure 3 ,
B
on the receiver).
10. Connect control devices. Connect your computer to the front panel Configuration
port (see figure 9 ,
B
on page 15 on the transmitter and receiver) to configure and
control the transmitter and receiver via SIS commands.
11. Power on the output display.