2
e
HDMI Output connector (Rx)
— Connect a display with an HDMI input for display of the
OUTPUTS
L R
AUDIO
transmitted direct digital image.
f
Audio Output connector (Rx)
— Connect a balanced or unbalanced stereo or mono
audio device to the receiver via the Audio captive screw connector. See the drawing below.
Unbalanced Stereo Output
Balanced Stereo Output
LR
Ring
Sleeve(s)
Tip
Tip
Ring
LR
Sleeve(s)
Tip
Tip
Do not tin the wires!
CAUTION:
Connect the sleeves to the ground contact.
DO NOT
connect the sleeves to the negative (-) contacts)
.
g
Power connector
— Connect an IEC power cord between the included 12 VDC power supply and a 100-240 VAC, 50-60 Hz
source. Connect the power supply to either unit as shown at right.
CAUTION:
This product is intended to be supplied by a Listed Power Unit
marked “Class 2” or “LPS,” rated 12 VDC, 1.0 A minimum.
Always use a power supply supplied by or specified by Extron.
Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the supply
and the end product. Unless otherwise stated, the AC/DC
adapters are not suitable for use in air handling spaces or in
wall cavities. The installation must always be in accordance
with the applicable provisions of National Electrical Code
ANSI/NFPA 70, article 75 and the Canadian Electrical Code
part 1, section 16. The power supply shall not be permanently
fixed to a building structure or similar structure.
NOTE:
Only one power supply is required. A single power supply
connected to either unit in the pair powers both units. A power
supply is included with each transmitter.
Operation
After all devices are powered up, the system is fully operational. See the definitions
Rear Panel
Rear Panel
Front Panel
Front Panel
POWER
12V
0.6 A MAX
2
1
of the power indications (shown at right), below:
a
Power LED (front panel)
—
Amber
— The unit is receiving power, either locally or remotely (on the DTP cable).
Green
— The unit is powered on and is receiving an active HDMI signal, either on
the HDMI input if a transmitter, or transmitted on the DTP cable if a receiver.
b
Power LED (rear panel)
—
Amber
— The unit is receiving power remotely (on the DTP cable).
Green
— The unit is receiving power locally.
If any problems are encountered, verify that the cables are routed and connected properly. If your problems persist, call the
Extron S3 Sales and Technical Support Hotline that is closest to you, at the number shown below.
Power Supply
Output Cord
SECTION A–A
Ridges
Smooth
A
A
Captive
Screw
Connector
Tie Wrap
3"
16 (5 mm) Max.
68-2156-50
Rev
A
07 11
Extron
USA - West
Headquarters
+
800.633.9876
Inside USA/Canada
Only
+1.714.491.1500
+1.714.491.1517
FAX
Extron
USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.863.1794
+1.919.863.1797
FAX
Extron
Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050
FAX
Extron
Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664
FAX
Extron
Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron
China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron
Middle East
+971.4.2991800
+971.4.2991880
FAX
© 2011 Extron Electronics. All rights reserved.
www.extron.com
DTP HDMI 301 • Setup Guide (Continued)