Extron electronics DTP HD DA 4K Series, User Manual, Page: 14 / 42

Extron DTP HD DA 4K Series • Installation and Operation 6
I
Reset button and LED (see figure 3 on page 4)— To reset the unit to factory
default settings, press and hold this Reset button for approximately 9 seconds. The
reset LED flashes green 3 times, once every 3 seconds. After the third flash, release the
button and quickly press it once more to complete the reset. The LED flashes green 3
times indicating that the default settings have been restored.
J
LAN (Ethernet) cport — Use an RJ-45 cable to connect this jack to a LAN (Ethernet)
for control of the device (see TP Cable Termination for Ethernet Communication
on page 8 for wiring details).
K
Remote RS‑232 port — To control the unit, connect an RS-232 device to this 3-pole,
3.5 mm captive screw connector and configure it as follows: 9600 baud rate, 8 data
bits,1 stop bit, no parity (see
Remote RS‑232 Control Wiring on page 8 for wiring
details).
Front Panel Features
CONFIG
DTP HD DA4 Series
INPUT OUTPUTS
SIGNAL
HDCP
DTP DISTRIBUTION AMPLIFIER
LOOP
THRU
3 4 1 2
CONFIG
DTP HD DA8 Series
INPUT OUTPUTS
SIGNAL
HDCP
DTP DISTRIBUTION AMPLIFIER
LOOP
THRU
3 4 5 6 7 8 1 2
A B F
E
D
C
A B F
E
D
C
Figure 5. DTP HD DA 4K Series Front Panel
A
Power status LED — Lights green when power is applied to the unit.
B
USB Config port — Used for firmware updates, SIS configuration, and software
control. This port can be used as an alternative to the rear panel Remote RS-232
captive screw connector (see
figure 3 ,
K
on page 4).
NOTES:
•
Neither port has precedence and commands from either port are handled in the
order they are received.
• Extron recommends that the USB port is used for temporary connections. If a
permanent connection is required, the RS-232 port or an IP connection should
be used.
C
Input Signal LED — Lights green when a signal is detected on the HDMI input.
D
Input HDCP LED — Lights green when HDCP presence is detected on the HDMI input.
E
Output Signal LEDs — Light green when a signal is detected on the HDMI outputs.
F
Output HDCP LEDs — Light green when HDCP presence is detected on the HDMI
outputs.
Reset button and LED
LAN (Ethernet) port
Remote RS-232 port
Front Panel Features
5