DTP DVI 230 D and HDMI 230/330 D • Setup Guide
This setup guide provides instructions for an experienced installer to set up and operate the
Extron DTP DVI 230 D and DTP HDMI 230 and 330 D extenders.
Installation
Step 1 — Prepare the Mounting Surface
NOTE:
Use a wall box with a depth of at least 3.0 inches (7.6 cm).
Alternatively, the included mud ring (MR 200) can be used.
For more information, see the full product user guides at
www.extron.com
. The installation must comply with the
National Electric Code.
a.
Place the wall box against the installation surface and mark the
opening guidelines.
TIP:
Use a level to mark the opening.
b.
Cut out the material from the marked area.
c.
Secure the wall box with 10-penny nails or #8 or
#10 screws, leaving the front edge flush with the surface.
d.
Run all required cables (see steps 4, 5, and 6) and secure them with
cable clamps.
TIP:
In order to fit the unit in the junction box, do not install
boots on TP cables and RJ-45 connectors.
Step 2 — Disconnect Power
Disconnect all equipment power sources.
Step 3 — Connect Inputs to the Transmitter
A
DVI or HDMI input connector
— Connect a DVI or HDMI cable between this port and the output port of the digital video source.
B
Local output (DTP DVI 230 D only)
— If desired, connect a DVI monitor for local monitoring of the input digital image.
C
DDC Route DIP switch (DTP DVI 230 D only)
— If the local output is not used,
set the DDC Route DIP switch to remote. Ensure that you power the local display
before powering the video source.
D
Audio input
— Connect an unbalanced stereo audio source to this 3.5 mm mini
stereo jack.
E
RS-232/IR Pass-Through connector
— Plug an RS-232 or modulated IR device
into the RS-232/IR Pass-Through port. Wire the cable as shown to the right.
Ground
Receive pin on connected unit
Transmit pin on connected unit
Connected RS-232
and IR Device Pins
Tx/Rx
Pins
Receive pin on connected unit
Transmit pin on connected unit
Rx
Tx
RS-232
IR
Rx
Tx
G
Signal Output
Cable
Cable
Clamp
Decora Faceplate
Extron
DTP DVI 230 D
Screws or
Nails
Wall opening is
flush with edge of box.
Wall Stud
LOCAL OU
T
Tx
Rx
G
Tx
Rx
RS-232
IR
INPUTS
DVI-
D
AUDI
O
INPUTS
LOCAL OU
T
DVI-
D
AUDI
O
Tx
Rx
G
Tx
Rx
RS-232
IR
INPUTS
LOCAL OUT
DVI-D
AUDIO
REMOTE
DDC
ROUTE
LOCAL
Tx Rx G Tx Rx
RS-232
IR
ON
1 2
INPUTS
AUDIO
Tx Rx G Tx Rx
RS-232
IR
OVER DTP
DTP DVI 230 D Tx
DTP HDMI 230/330 D Tx