CVEQ1 Series • Installation, Setup, Operation
Installation, Setup, Operation, cont’d
CVEQ1 Series • Installation, Setup, Operation
2-11
Mounting the CVEQ1 WM
The CVEQ1 WM must have output cables connected before it
is installed in a wall or furniture. Secure the CVEQ1 WM to the
wall box as shown below.
Installation Cable
Cable Clamp
Wall Stud
CVEQ1 WM Install.eps
CV
EQ
1 W
M
L A
UDIO IN
R
AU
DIO IN
VIDEO IN
Mounting the CVEQ1 WM into a wall box
Mounting the CVEQ1 AAP
The CVEQ1 AAP and any other adapter plates must be attached
to a device’s faceplate or an AAP wallplate and cabled before the
device or wallplate is installed in a wall or furniture. The screws
needed for installing the CVEQ1 AAP are built into its front
panel, so no additional screws are needed.
1
.
Insert the CVEQ1 AAP’s screws through the holes in the
faceplate or AAP wallplate. Secure the line driver to the
faceplate or wallplate with the provided captive washers
and #4-40 nuts.
#4-40 Nut w/ Captive
Washer
CVEQ1 AAP w RGB 568 installation.eps
4-gang Wall Box
RGB 568
CVEQ1 AAP
RGB 568
INPUT
BUFFERED
LOCAL MON
ITOR
POW
ER
AUT
O
ID PIN 11
ID PIN 4
CS PIN 9
H. SHIFT
AUDIO
EQ
UALIZE
GAIN
AUDIO INPUT
VID
EO INPUT
L
R
CVEQ1 AAP
Mounting the CVEQ1 AAP to an interface
or wallplate and into a wall box
2
.
Follow steps 3 through 8 in the Quick Start Guide at the
front of this manual.
2-10
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
