Table 4: Contents of the AP7662i/AP7662 Box
Quantity
Item
1
AP7662i/AP7662 Quick Reference Guide
1
Cloud Quick Start Card
1
AP7662i/AP7662 Access Point
The following hardware is included:
1
M4 screw assembly with star washer
1
Ring terminal
Positioning the AP for Installation
Mount the AP so that the glands are on the side of the AP closest to the ground, and not above the
plastic cover. You must provide a 3-inch drip loop on all cables.
Note
Do not remove the dust cap until you need to install the BLE/ IoT antennas.
Attach the Ground Wire
Use the M4 ground screw assembly, with the star washer, to attach the ground wire’s ring terminal to
the back of the AP. The wire should be as close to the AP bottom as possible. Tighten the screw to a
torque of 13.0-13.5 in-lbs.
Note
Attach the H bracket after attaching the ground wire onto the AP. Tighten the torque, tighten
the screws, and attach the LAN cable.
Mounting Brackets Usage for AP7662i/AP7662
The AP7662i/AP7662 does not come with any mounting bracket. Hence, they need to be purchased
separately. Refer the table below for information on mounting brackets used with the access point and
it's specifications.
Hardware Mounting and Installation
ExtremeWireless WiNG™ AP7662i/AP7662 Access Point Installation Guide
11