SERVICE AND MAINTENANCE OF YOUR DRYER
GENERAL OPERATION
This dryer is activated by an infrared sensor. The dryer operates as long as hands are below
nozzle. There is a maximum 80 second running time with a safety over-ride feature, if hands
are not removed. Each component used in your dryer has been designed to provide years
of trouble-free service. However, if trouble should develop, it can normally be located
by visual examination. Removal or replacement of most parts, is simple and can be done
without special tools.
IF THE DRYER WON’T TURN ON:
Check electrical service, circuit breaker. Make sure proper voltage is being supplied to the
dryer. Check for loose or disconnected terminal to sensor. INCREASE sensitivity (
F
igure
3
) by inserting a flat-blade screwdriver through the hole and into the pot to CAREFULLY
turn the adjustment pot located on the sensor CLOCKWISE
1/3 Turn MAX
. If necessary,
replace sensor.
IF DRYER WILL NOT SHUT OFF:
Make certain black foam is attached to lens and lens is clean. If damaged, replace.
DECREASE sensitivity (
F
igure
3
) by inserting a flat-blade screwdriver through the hole and
into the pot to CAREFULLY turn the adjustment pot located on the sensor.
1/3 Turn MAX
.
COUNTER-CLOCKWISE. If necessary, replace sensor.
IF COLD AIR IS COMING FROM THE NOZZLE:
Turn off breaker for 30 seconds to reset thermostat. If necessary, inspect heating element
by unfastening blower housing from backplate (3 screws). Remove heating element from
blower housing to inspect for damage. Replace if necessary.
IF NO AIR IS COMING FROM THE NOZZLE:
If the dryer also trips the circuit breaker, replace the motor/blower assembly by unfastening
the blower housing from the backplate (3 screws) and remove the inlet shield. Otherwise,
replace the sensor.
FOR ANY OTHER PROBLEM, CONTACT FACTORY FOR ASSISTANCE.
CLEANING -
DO NOT spray cleaning solvents thru dryer vents. DO NOT use abrasive,
chlorinated, or highly alkaline cleaners. DO NOT use oil based cleaners.
SEMI-ANNUALLY remove the cover and clean all lint and dust from the mechanism, inside
of cover, and plastic window.
Clean cover with a mild soap or detergent and warm water, using a soft cloth or sponge.
PARTS LIST FOR YOUR DRYER (Figure 2)
ITEM
PART NO.
DESCRIPTION
1
GXT202
COVER, WHITE ABS (MUST SPECIFY DRYER MODEL #)
2
GXT202-M COVER, WHITE STEEL (MUST SPECIFY DRYER MODEL#)
3
GXT202-C
COVER, CHROME PLATED STEEL (SPECIFY DRYER MODEL #)
4
GXT212
NOZZLE ASS’Y W/ LENS AND FOAM GASKET
5
GXT216
MOTOR/BLOWER, 110-120V (GXT6-M/C)
6
GXT217
MOTOR/BLOWER, 208-240V (GXT8-M/C)
7
GXT218
HEATING ELEMENT ASS'Y 110-120V (GXT6-M/C)
8
GXT220
HEATING ELEMENT ASS'Y 208-240V (GXT8-M/C)
9
GX239
SENSOR COMPLETE, 110-240 VOLT
10
GB232
TAMPER-PROOF SCREWS & SECURITY WRENCH
DISCONNECT POWER BEFORE SERVICING
DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES
WARNING:
F
igure
3
S
enSitivity
A
DjuStMent
+
-
F
igure
2 - E
xploDeD
v
iew
1
2
5 6
9
7
8
4
10
3