Extreme Networks ExtremeWireless AP560h, Installation Manual, Page: 15 / 40

Table 7: AP560h mounting brackets and accessories usage (continued)
Mounting bracket/
accessory and part
number
Wall install Pole install Notes
WS-MBO-POLE01
(#30520); bracket; also
known as the pole
mounting bracket
No Yes If the pole diameter is
<= 1.0 in. (25.4 mm), use
small cable clamp. If the
pole diameter is
between 5.0 in. (127.0
mm) – 7.0 in. (178.0
mm), use large cable
clamp. For any other
pole diameter, provide
your own stainless steel
cable clamp. The band
must be 0.5 in. (12.7mm)
wide. The POLE01
bracket can be used
only when paired with
the MBO-ART02
bracket.
MBO-ART02; 10 in. 2-
axis articulating
mounting bracket
Yes Yes The articulating
mounting bracket is
used with POLE01
bracket for pole install.
The wall must be strong
enough to support the
access point during
inclement weather.
Note
The access point cannot be installed without the mounting bracket.
Install the Access Point on a Wall
Before You Begin
The access point is used with the KT-147407-02 bracket parts for wall installation. The KT-150173-01
extension arm is also used with the access point and the KT-147407-02 bracket parts for wall and flat
surface installation.
Other wall install options include using the:
•
MBO-ART02 bracket
The following hardware is required when installing the access point on a flat surface using the
KT-147407-02 bracket:
•
One access point
•
Flat part of the KT-147407-02 bracket with two holes on the metal surface (see Flat part of the
KT-147407-02 bracket ).
•
1-axis tilt bracket (see Figure 6 on page 20).
Install the Access Point Install the Access Point on a Wall
ExtremeWireless™ AP560h Access Point 15