6. Align the access point back slots with the stainless-steel bracket access point holding tabs, and then
slide the access point onto the bracket until it is fully seated in place.
7. Using a security torx T-8 or a VT-8 screw, secure the bracket locking tab for physical security.
Install the Access Point on a EU Model Junction Box Using the ACC-BKT-AX-WP-
EXT Accessory
Before You Begin
Hardware required for installation with extension accessory:
•
One AP302W access point
•
One stainless-steel wall plate bracket
•
One ACC-BKT-AX-WP-EXT accessory
•
Four Phillips washer pan head M2.5×7 mm long screws to attach the extension to the wall plate
bracket
•
Two Phillips pan head M3.5×38 mm long screws for wall plate bracket mounting
•
Two Phillips flat head 6–32×35 mm long screws for junction box attachment
•
One flat head T8 security torx M2.5×6.5 mm long locking screw
•
One 100 mm RJ45 cable (not including connectors), CAT.5E flat LAN cable
About This Task
If the RJ45 connector protrudes from the junction box face plate, you need a 20 mm extension between
the junction box and the access point during installation to place the RJ45 cable. Use the ACC-BKT-AX-
WP-EXT accessory with the stainless-steel mounting bracket for providing extension.
Note
You must purchase the -EXT extension accessory separately.
Procedure
1. Using the stainless-steel mounting bracket as a template, mark and drill two mounting holes around
the junction box faceplate.
The mounting holes must be located above and below the junction box face plate.
Install the Access Point
Install the Access Point on a EU Model Junction Box
Using the ACC-BKT-AX-WP-EXT Accessory
ExtremeWireless™ Access Point AP302W
27