Extreme Networks ExtremeSwitching VDX 6740, Hardware Installation Manual

Page: 64 / 135

Flush-front mounting
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
The illustrations in the rack installation procedures are for reference only and may not show the device that you are installing.
Complete the following tasks to install the device in a four-post rack.
1. Attaching the front brackets on page 64
2. Attaching the bracket extensions to the device on page 65
3. Installing the device in the rack on page 66
4. Attaching the rear brackets to the extensions on page 67
5. Attaching the rear brackets to the rack posts on page 68
Attaching the front brackets
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device at the front of the device, as shown in Figure
42 .
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the
side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat step 1 and step 2 to attach the left front bracket to the left side of the device.
Installing the Universal Four-Post Rack Kit (XBR-R000296)
ExtremeSwitching VDX 6740 Hardware Installation Guide
64 9036108-00