•
Plan for the rack space required for cable management before installing the device.
•
Leave at least 1 m (3.28 ft) of slack for each port cable. This provides room to remove and replace the device, allows for
inadvertent movement of the rack, and helps prevent the cables from being bent to less than the minimum bend radius.
•
For easier maintenance, label the cables and record the devices to which they are connected.
•
Keep LEDs visible by routing port cables and other cables away from the LEDs.
Quick installation checklist
This checklist provides a high-level overview of the basic installation process from the planning stage to the point where the device
comes online and is ready to be deployed. Completing all the tasks in the suggested order ensures successful installation. Extreme
Networks recommends that you print this checklist and take it to the installation site.
Follow the steps listed in the
to install your device. Details for each of these steps are provided on the pages indicated.
TABLE 8
Installation prerequisites
Task
num
ber
Task
Task details or additional information
Completed
1
Ensure that the physical environment that
will host the device has the proper cabling
and ventilation.
Refer to
on page 19.
2
If customizing an SLX 9540 Switch
baseline chassis:
1.
Install at least one power
supply unit.
2.
Install at least five fans.
Refer to
Inserting a new AC power supply
Refer to
Inserting a new DC power supply
Refer to
3
Mount the device on a desktop or in a
rack
Refer to
Installing the device in a rack
4
Attach a terminal or PC to the device. This
will enable you to configure the device
through the command line interface (CLI).
Refer to
Establishing a serial connection
5
Assign a password for additional access
security. No default password is assigned
to the CLI.
Extreme SLX-OS Management Configuration Guide
6
Before attaching equipment to the device,
you must configure an interface IP
address to the subnet on which the device
will be located. Initial IP address
configuration is performed using the CLI
with a direct serial connection.
Extreme SLX-OS Management Configuration Guide
7
Connect an Ethernet connection to the
system.
Refer to
Establishing an Ethernet connection
on page 57.
8
Test IP connectivity to other devices by
pinging them and tracing routes.
Extreme SLX-OS Management Configuration Guide
9
Continue configuring the device using the
CLI.
Extreme SLX-OS Management Configuration Guide
10
Secure access to the device.
Extreme SLX-OS Management Configuration Guide
Quick installation checklist
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB
21
Summary of Contents for ExtremeSwitching SLX 9540
