Altitude 4600 Series Access Point Installation Guide
31
WARNING!
Operation of the device without regulatory approval is illegal.
Country Selection - Note for AP & Wireless Switch
Select only the country in which you are using the device. Any other selection will
make the operation of this device illegal. The US version of the Access Point will only
have US listed in the country selection table. The US version will be sold / used in the
US protectorates: American Samoa, Guam, Puerto Rico, US Virgin Islands.
The AP4600 series ROW models will list many countries where it’s the professional
installer’s and end user’s responsibility to properly follow these instructions to set-up
the access point.
Although outdoor use may be allowed and may be restricted to certain frequencies
and/or may require a license for operation, the Altitude 4600 Series Access Point is
intended for indoor use and must be installed in a proper indoor location. Use the
installation utility provided with the controller software to ensure proper set-up in
accordance with all European spectrum usage rules. Contact local Authority for
procedure to follow and regulatory information.
Frequency of Operation - FCC and IC
5 GHz Only
The use on UNII (Unlicensed National Information Infrastructure) Band 1 5150 - 5250
MHz and Band 3 5470 - 5725 MHz is restricted to indoor use only, any other use will
make the operation of this device illegal.
Devices using the 5470 - 5725 MHz band shall not be capable of transmitting in the
band 5600 - 5650 MHz in the US, this “Notched” band has been disabled in the US
version of the Access Point.
The available channels for 802.11 b/g operation in the US are Channels 1 to 11. The
range of channels is limited by firmware.