2
4. Connect the velcro on roof corners to the
velcro on the corners of the marquee legs.
8. Lift all four roof connectors until pins lock
in to position. Stand on foot plate and lift with
two hands until you hear a ‘Click’.
7. Ensure there are no trip hazards. Walk
backwards and open frame fully.
11. Extend back legs by repeating step 10.
Once the marquee is set up
REFER TO
SECURING YOUR MARQUEE.
2. Open frame 75% of full extension.
1. Remove all your items from packaging and
clear a safe area.
5. Fit the peak of the roof to the centre poles
of the marquee and tighten the toggle.
9. Ensure protective flaps are over the truss
connectors. This will protect the roof from
wear. Attach them by looping the straps
around the truss and engaging the clips, then
tighten.
3. Fit the roof to the frame.
6. Refer to ‘LIFT HERE’ sticker. Grasp the
marquee truss bars.
10. Extend the front marquee legs. Using
one foot, stand on the marquee foot plate,
release the pull ring on the middle leg
connector and extend front legs to desired
height.
3MX6M MARQUEE SETUP
REFER TO NEXT PAGE >>
SETUP INSTRUCTIONS
Please read instructions completely before setting up your marquee. Make sure you have all the parts identified on the Parts List.
Recommended procedure below. For safety reasons it is recommended that 2 persons set-up / pack down any marquee.
