17
25.
Next we’ll install the rudder servo and pull-pull system. Use the manufacturer
supplied hardware to mount the rudder servo in the tray as shown. Use either the
double arm supplied with the servo or the double arm that is part of the Dubro set.
26.
There is a tube on each side of the fuselage just ahead of the rudder horn for the
pull-pull cables to pass through. Locate these holes and pierce with the end of the
cable. Insert the cable and push it through to the radio compartment, making sure
it doesn’t wrap around any of the formers.
27.
I prefer to attach the cable at the rudder horn end first. Use a piece of masking
tape to secure the rudder counter balance to the vertical fin. Slide one of the
crimps onto the end of the cable and insert the cable through the hole in the rudder
control horn and back through the crimp. Use a pair of side cutters to crimp the
tube over the cable.
