18. Slide the fairings over the landing gear and against the sides of the fuselage. You may
need to open the hole in the fairing slightly with a rotary tool bit for proper fit. Use a
pencil to mark the location of the bottom of the fairing on the landing gear and then
remove the fairing.
19.Apply a thick bead of silicon glue or epoxy just below your pencil line all the way
around the gear. Slide the fairing back into place and apply masking tape to keep it
in position while the glue dries.
18
20. Locate the 2 axles, 2 locking nuts, 2 wheels, 2 wheel collars and 2 wheel pants from the
hardware package. Place the wheel onto the axle and secure with a wheel collar. Place
the threaded portion of the axle through the hole in the landing gear and screw the lock
nut onto the axle, but do not tighten completely. There is a slot pre-cut in the wheel pant
to allow it to fit over the axle. Slide the wheel pant into position over the axle and tighten
the nut on the axle, taking care to make
sure the wheel pant is positioned properly.
Summary of Contents for 78" EXTRA 300 ARF
Page 1: ...78 EXTRA 300 ARF Instruction Manual Copyright 2009 Extreme Flight RC ...
Page 8: ...8 ...
Page 9: ...9 ...
