21.Scuff the portion of the control horn that will insert into the elevator as well as the
bottom of the base plate with sandpaper. Secure the control horn to the elevator with
epoxy just as you did with the aileron horns.
22. Slide the elevator onto the hinges in the stabilizer making sure the hinges are
centered in the hinge gap and secure with thin CA.
23. Before moving to the next step, it would be a good time to seal the hinge gap with
a strip of Ultracote or Blenderm tape. Also, take a few minutes to go over all of the
seams in the covering with a sealing iron on a medium heat setting, paying special
attention to stripe edges and ends.
16