Extreme Flight 104 Laser EXP ARF, Assembly Manual

Page: 9 / 30

Figure 5
Figure 6
Now take your3mm bolt, then insert a washer, then thru the ball link, next install the
conical then thread the bolt onto the servo arm and use BTL. If using an EF servo arm,
they have double thickness and a locknut is not necessary but can be installed if desired,
however on other brand arms a locknut is usually necessary as they are not as thick. Once
again check the servo for center and direction of travel, if correct you may hook the
remaining end of the pushrod to the control horns. See figures 7 & 8 for final assembly.