Install an SSL Decryption Board
2
Discover appliance
Slot Number
EDA 10200
8
Note:
There is no external port on the SSL card.
3. Lift up the blue expansion card latch to remove the PCI slot cover.
4. Holding the card by its edges, position the card so that the connector on the expansion card aligns with
the expansion card connector on the riser.
5. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
6. Close the expansion card latch.
A
SSL decryption card
B
Expansion card latch
C
Expansion card riser
D
Expansion card connector
Figure 1: Installing the SSL card into the expansion card riser in the EDA 9100
Install the cover
Important:
Ensure that all internal cables are connected and placed out of the way and no tools or
extra parts are left inside the Discover appliance.
1. Align the slots on the cover with the tabs on the chassis.
2. Push the cover latch down to move the system cover into the closed position.
The cover slides forward and the tabs on the cover engage with the slots on the chassis. The cover latch
locks into place when the cover engages with the slots on the chassis.
