Deploy the ExtraHop Discover 8200 Appliance
4
3. At the password prompt, type the system serial number and then press ENTER. The serial number is
printed on a label on the back of the appliance. The serial number can also be found on the LCD display
on the front of the appliance in the
Info
section.
4. Enable privileged commands:
enable
5. At the password prompt, type the serial number, and then press ENTER.
6. Enter configuration mode:
configure
7. Enter the interface configuration mode:
interface
8. Run the
ip
command and specify the IP address and DNS settings in the following format:
ip ipaddr
<ip_address> <netmask> <gateway> <dns_server>
For example:
ip ipaddr 10.10.2.14 255.255.0.0 10.10.1.253 10.10.1.254
9. Leave the interface configuration section:
exit
10. Save the running config file:
running_config save
11. Type
y
and then press ENTER.
Configure the Discover appliance
After you configure an IP address for the Discover appliance, open a web browser and navigate to the
ExtraHop Web UI through the configured IP address. Accept the license agreement and then log in with the
setup
user account. The password is the system serial number that appears in the
Info
section of the LCD
display and on the label on the back of the appliance.. Enter the product key to license the appliance.
After the appliance is licensed, and you have verified that traffic is detected, complete the recommended
procedures in the
