64
65
EN
4. Press the button again to light up the LED lamp and there
will be voltage in the USB socket. It is possible to charge
electronic devices and have the lamp lit at the same time.
5. Pressing the button for a third time will turn off the
lamp but there will be voltage in the USB socket if an
electronic device that is being charged is connected.
•
ATTENTION
The battery has electronic protection
against complete discharge, which
damages it. The protection does not
allow voltage to fall below a certain
level, which manifests itself by el.
current being suddenly cut off when the battery is flat (see
indicator lights on the battery). As a result of the electronic
protection against sudden complete discharge of the battery,
it may happen that the charging of electronic devices may be
suddenly stopped and/or the lamp may turn off.
VI. Safety Instructions
SAFETY INSTRUCTIONS
FOR THE CHARGER
y
Read the user‘s manual before charging.
y
The charger is intended only
for charging indoors. It is necessary
to protect it against rain, high humi-
dity and temperatures over 40°C.
y
Prevent the charger from being used by persons
(including children) whose physical, sensory or
mental disability or incapacity or insufficient experi-
ence or knowledge prevents them from safely using
the appliance without supervision or instruction.
ning two batteries will start. Not all 4 batteries
are charged simultaneously.
5. To remove the battery, press the button on
the battery and pull the battery out of the
grooves of the charger.
6. When not using the charger any more, disco-
nnect it from the el. power source.
V. Using converter
Extol® Premium 8891896
y
The converter is intended only for use with batteries
from the SHARE 20 V cordless program. Using diffe-
rent batteries may cause damage to the converter or
the charged electronic device.
y
The converter is intended for charging mobile phones
and other electronic devices designed to be powered
via a USB 5V-2A socket and/or as an LED lamp.
1. Put the converter into the grooves of the battery so that
the converter clicks into the battery (it is secured in place).
2. Insert a USB cable plug of the charged electronic
device into the USB socket of the converter.
3. When the button on the converter is pressed for the
first time, there will be voltage in the USB socket
(the connected electronic device will be charged)
and the red indicator light on the converter will
be lit. If the button is not pressed, there will be no
voltage in the USB socket. If no electronic device is
connected to the converter for charging, then the
indicator light will turn off after a few moments
and there will be no voltage in the USB socket.