Extended Systems ExStik DO600, User Manual

Page: 12 / 13

DO600-en-EU_V7.2 09/14 12
Operational Matrix for the Model DO600
Function /
Resulting
Action
Power
Status
Mode
Setting
Required Button Press Sequence Comments
On/Off Any Any Momentary press of the ON/OFF button
Water Saturated
Air Calibration
On Any Place Electrode in Calibration Cap
Press & hold CAL/RECALL button for 2 seconds
Zero Calibration
On Any
Place Electrode in Zero Solution, wait for stability Press
& hold CAL/RECALL button for 2 seconds
Also works with probe
removed (Cal at zero current)
Store Reading
On Any Momentary press of the MODE/HOLD button
Stores and holds reading
“HOLD” displayed
Hold Release
On
While In
Hold
Mode
Momentary press of the MODE/HOLD button
Enter Memory
Retrieval
On Any
Momentary press of the Cal button followed by
a momentary press of the MODE/HOLD button
(w/in 4 seconds)
If no data is stored in
memory, “End” is displayed
briefly, and then returns to
last mode.
Scroll Stored
Readings
On
Memory
Recall
Momentary press of the MODE/HOLD button
Exit Memory
Retrieval
On
Memory
Recall
Momentary press of the CAL/RECALL
Clear Stored
Memory
On
Any
Measure ‐
ment Mode
Press and hold the ON/OFF button for 4 seconds “clr” is displayed.
Change
Measurement
Mode
On Any
Press and hold the MODE/HOLD button for at
least two seconds (the modes will scroll until
the button is released)
Enter Salinity
Compensation
On Any
Press and release the CAL/RECALL button twice
(momentary) in succession (Displays SAL)
Changing
Salinity
Compensation
On SAL
Momentary press of the MODE/HOLD button
(each button press increases the ratio by 1 ppt
(part per thousand), the value cycles from 0 to
50)
Exit Salinity
Compensation
On SAL
Press and release CAL/RECALL button for 2
seconds to enter Altitude Compensation, Or
Press and release Cal Button one more time to
enter measurement mode
It is necessary to press the
CAL/RECALL button to save
changes. If the unit times out,
no changes are saved.
Enter Altitude
Compensation
On
Any or
SAL
Press CAL/RECALL twice (momentary). Unit
enters Salinity Mode. Press CAL/RECALL for 2
seconds to enter Altitude Compensation Mode.
(Displays Ald)
Unit times out in 5
seconds if no button is
pressed, reverts to
previous mode.
Changing
Altitude
Compensation
On Ald
Momentary press of the MODE/HOLD
button(each button ‐ press increases altitude by
1,000ft, the value cycles from 0 to 20)
Exit Altitude
Compensation
On Ald
Momentary press CAL/RECALL button to exit
and save changes.
It is necessary to press the
CAL/RECALL button to save
changes. If the unit times out,
no changes are saved.
Change
Temperature
Units
Off
n/a (off
mode)
Press and hold the CAL/RECALL button then
momentarily press the ON/OFF button. Release
the CAL/RECALL button after the "SELF CAL"
lights
Override
Autopower Off On Any
Press CAL/RECALL button (momentary) then
simultaneously press and hold the MODE/HOLD
and ON/OFF buttons for for 2 seconds.
Default Reset
Off
n/a (off
mode)
Simultaneously press ON/OFF, CAL/RECALL and
MODE/HOLD momentarily. “dFLt” will be
displayed.
netzerotools.com
netzerotools.com