9 SDL400-en-GB_V1.6 12/14
Automatic Datalogging
In automatic datalogging mode the meter takes and stores a reading at a user-specified sampling
rate onto an SD memory card. The meter defaults to a sampling rate of one second. To change the
sampling rate, refer to the Setup Mode section (the sampling rate cannot be ‘0’ for automatic
datalogging):
1.
Select the sampling rate in the Setup Mode (refer to Setup Mode section) to a value other than
zero.
2.
Press and hold the LOG button for at least 1.5 seconds. The meter will flash the REC icon at
the selected sampling rate indicating that readings are now being automatically recorded to the
SD card. Note that if the battery is low, the meter will flash the BAT icon and datalogging will
not commence. Replace the batteries at this point (see Battery Replacement section of this
guide)
3.
If a card is not inserted or if the card is defective, the meter will display SCAN SD indefinitely.
In this case, switch the meter OFF and try again with a valid SD card.
4.
Pause the datalogger by pressing the LOG button momentarily. The REC icon will stop
flashing and the sample rate will display for a short time. To resume logging simply press the
LOG button again momentarily.
5.
To terminate the datalogging session press and hold the LOG button for at least 1.5 seconds.
6.
When an SD card is used for the first time a folder is created on the card and named
LXB01
.
Up to 99 spreadsheet documents (each with 30,000 readings) can be stored in this folder.
7.
When datalogging begins a new spreadsheet document named
LXB01001.xls
is created on
the SD card in the LXB01 folder. The data recorded will be placed in the LXB01001.xls
document until 30,000 readings are reached.
8.
If the measurement session exceeds 30,000 readings, a new document will be created
(LXB01002.xls) where another 30,000 readings can be stored. This method continues for up to
99 documents, after which another folder is created (LXB02) where another 99 spreadsheet
documents can be stored. This process continues in this same fashion with folders LXB03
through LXB10 (last allowable folder).
SD Data Card to PC Data Transfer
1.
Complete a datalogging session as detailed above in the previous sections. Hint: For the first
few tests, simply record a small amount of test data. This is to ensure that the datalogging
process is well understood before committing to critical, large scale datalogging.
2.
With the meter switched OFF, remove the SD Card.
3.
Plug the SD Card directly into a PC SD card reader. If the PC does not have an SD card slot,
use an SD card adaptor (available at most outlets where computer accessories are sold).
4.
Power on the PC and run a spreadsheet software program. Open the saved documents in the
spreadsheet software program (see example spreadsheet data screen below).
