EX613-EU-EN-V2.6-4/12
10
Data Hold
To freeze the LCD reading, press the
HOLD
button. While data hold is active, the
HOLD
icon
appears on the LCD. Press the
HOLD
button again to return to normal operation.
MAX/MIN
1. Press
the
MAX/MIN
button to activate the MAX/MIN recording mode. The display icon "
MAX
"
will appear. The meter will begins recording and displaying the maximum value measured.
2. Press
the
MAX/MIN
button and “
MIN
” will appear. The meter will display the minimum value
measured during the recording session.
3. Press
the
MAX/MIN
button and “
MAX
MIN
” will appear. The meter will display the present
reading, but will continue to update and store the max and min readings.
4. To exit MAX/MIN mode press and hold the
MAX/MIN
button for 2 seconds.
Peak Hold
When ACA or ACV is selected, pressing the
PEAK
button enables the peak capture circuit. The
meter will now capture and display the maximum and minimum peaks of the waveform.
RANGE
In the Voltage, Resistance, Capacitance, Frequency or uA function the meter automatically selects
the best range for the measurements being made. For measurement situations requiring that a
range be manually selected, perform the following:
1. Press
the
RANGE
button. The “
AUTO”
display icon will turn off.
2. Press
the
RANGE
key to step through the available ranges. Observe the decimal point and
units displayed until the preferred range is located.
3.
To exit the Manual Ranging mode and return to Autoranging, press and hold the
RANGE
key
for 2 seconds.
LCD Backlight
The LCD is equipped with backlighting for easier viewing, especially in dimly lit areas. Press and
hold the
HOLD/
button for 2 seconds to turn the backlight on. The backlight will automatically turn
off after 30 seconds.
Automatic Power OFF with Disable
In order to conserve battery life, the meter will automatically turn off after approximately 30 minutes.
To turn the meter on again, turn the function switch to the OFF position and then to the desired
function position.
To disable APO:
1. From the OFF position, hold the MODE button and rotate the FUNCTION switch to a
measurement function.
2.
will appear in the display
3. Release the MODE button
4. APO is now disabled (APO icon is off) and will be reset when the Function switch is returned to
the OFF position.
Low battery indication
When the
icon appears in the display, the battery should be replaced. Refer to the battery
replacement procedure in the maintenance section.
