Extech Instruments CLT600, User Manual

Page: 14 / 30

Receiver Operating Modes
5
5.1 Automatic Detection Mode
When the power is on, the Receiver defaults to the auto detection mode
where it can trace the high frequency transmission signal at the highest sensi-
tivity. The Receiver responds to the detected signal with a variable tone (550
Hz ~ 1.6 kHz) and a bar-graph indication. The stronger the signal, the higher
the frequency of the tone and the higher the number of bars in the bar-graph.
The receiver displays SIG (Signal) and the numeric value of the received sig-
nal strength. The optional transmission identifier Code, sent from the Trans-
mitter, is also displayed.
5.2 Manual Detection Mode
Press the M button to access the manual detection mode where you can se-
lect the signal sensitivity level (8 steps) using the up/down arrow buttons.
Press the
M button to return to the Auto Detection mode.
5.3 Non-Contact Voltage Detection Mode (U
AC
)
Press the U
AC
button to access the non-contact voltage detection mode. In
this mode you can detect a voltage source without having to make contact
with the wiring, circuit, AC power line, or wall outlet.
#NAS100035; r. AA/71038/71038; en-US 10