4
Scale Description
1. Scale platform
2. Adjustable scale legs
3. Programming keypad
4. LCD display
5. Display locking nut
6. Display arm
7. Allen screws for display arm adjustment
8. AC adapter/recharger input (rear of display)
Preparation
1. Place the scale on a firm, stable tabletop before use. Level the scale by adjusting the scale legs.
2. Do not expose the scale to high wind, fluctuating temperature/humidity, vibration, or direct
sunlight. Avoid dust, sand, and other particulates when using the scale.
3. Adjust the display arm by loosening the two allen screws (using supplied allen wrench) and then
positioning the arm to be at a 90
o
angle from the scale platform. Tighten screws.
4. The scale is powered by an internal rechargeable battery. The supplied AC adapter is used for
recharging. When the LOBATT display arrow appears connect the AC adapter/recharger to the
scale then plug the adapter into a 110V 50/60Hz receptacle to begin charging the battery. When
the LoBatt indicator arrow turns off, the battery is fully charged. The scale can be used while
charging.
5. To optimize the accuracy of the scale’s readings, warm up the scale for 30 minutes. Do not leave
weight on the scale while it is warming up. Connect the AC Adapter to the Scale and to an AC
receptacle (110VAC 50/60Hz) to warm up the scale since the Auto Power OFF feature will
automatically power the scale down after 5, 10, 20, or 30 minutes of non-use (programmable).
Auto Power OFF can be defeated, refer to the section entitled “Auto Power OFF Configuration”
later in this manual for instructions on configuring the Auto Power OFF feature.
