Extang Corporation, 1901 E. Ellsworth Rd., Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409, Visit us at:
www.extang.com
8
6
Place the rail assembly over the side of the truck box. Center
rails evenly between cab and tailgate.
(
NOTE
: Some applications
have hard rubber risers (square rubber pad.) A riser must go toward tailgate.
Some applications will have a riser at both ends, (most have no riser).
5
Clamp Spacing
(Same for each side)
See the stickers located on each side rail for clamp
position, or refer to the dimensions given below.
Note: Remove stickers after installation.
Insert clamp bolt in place.
Do Not Overtighten
Insert bow onto top or bottom peg.
(Top peg for performance, Bottom for good looks.)
Ends are spring loaded
for easy installation.
Push and hold on
spring end and let the
other end slide on with
the spring action.
SPECIAL
FEATURE:
Two pegs
offer two
height
adjustments.
Note:
Bow End does not
fit between pegs.
8
Attach tarp by starting
at the corners, and
snap in place.
EASY USE OF TRUCK BED
Tarp may be rolled up and secured with
Velcro® for bulk hauling
Studs Down
Slides Off
Rotate 180
°
Studs Up
SUMMER SETTING
Takes up slack in tarp
caused by warm weather.
WINTER SETTING
Allows more slack in tarp
for cold temperatures.
7
When positioning wall plates be sure that they fit correctly against the truck bed wall.
The plates must seat against the bottom of, and parallel to, the wall indentation.
12
inches
12
inches
Center middle clamp
Note: Measure all distances from screw hole centers.
9
Press wall plate
firmly in place.
Allow wall
plates to set
over night.
For an OVER-THE-RAIL Bedliner
A
DIAGRAM
B
DIAGRAM
Note: For over-the-rail bed liners first refer to Diagrams A and B below.
Upper
Peg
Lower
Peg
Do Not
Place
Between
the Pegs
Start at
Corners
TIGHTER
LOOSER
TIGHTER
LOOSER
TIGHTER
LOOSER
TIGHTER
LOOSER
After wall plates
have set, insert side
rail clamp all the
way into rail.
SPECIAL FEATURE
Weather-adjustable Snaps
Place Clamp
Here
STICKER
For each clamp mark on your bedliner a 1-1/2” x 3” hole
as shown above. Remove clamp. Cut holes in bedliner.
Reinsert side rail clamp. Return to step 6.
Side rail clamped to bed with
bow attached.
