25
EX
-
6124
English
© Copyright 2021 by EXSYS Vertriebs GmbH. All Rights Reserved
7. DIP
-
Switch Settings
There are four 4
-
pin DIP
-
switches inside on the EX
-
6124 board. To do this, you need to unscrew
the four screws on the sides of the EX
-
6124 and loosen the top case. There is a separate DIP
-
switch for each port. In most cases you do not have to make any changes to the DIP
-
switches!
The DIP
-
switches are all set to "OFF" when shipped from the factory. The settings can be adjusted
individually for each serial port. Please refer to the following figure on page 13 for the assignment
of which switch controls which port. From the following tables on page 13 you can see the setting
of the DIP
-
switches.
DIP
-
Switch
for Port 1
DIP
-
Switch
for Port 2
DIP
-
Switch
for Port 3
DIP
-
Switch
for Port 4
Important!
RS
-
232
: Please make sure that all switch pins MUST be set to "
OFF
"!
RS
-
422 & RS
-
485
: The switch pins are defined as follows:
Pin1: Enable the 1K
-
Pull
-
Up
-
Resistor of the RX+
Pin2: Enable the 1K
-
Pull
-
Down
-
Resistor of the RX
-
Pin3: Enable the 120 Ohm termination resistor between RX+ and RX
-
Switch Pin
Function
Pin Position
Description
1
1K
-
Pull
-
Up
-
Resistor of the RX+
OFF (Factory Setting)
Disabled
ON
Enabled
2
1K
-
Pull
-
Down
-
Resistor of the RX
-
OFF (Factory Setting)
Disabled
ON
Enabled
3
120 Ohm Terminator
OFF (Factory Setting)
Disabled
ON
Enabled
4
Without Function
OFF (Factory Setting)
-
ON
-
ON
4
3
2
1
