13
EX
-
1188HMS
-
3
English
5. Driver Installation
All Operating Systems
After the hardware installation the OS will recognize the device automatically and install the driv-
ers.
CHECK INSTALLED DRIVER
Open the >
Device manager
<. Now you should see at
„
Ports (COM & LPT)
“
&
„
USB
-
Controller
“
the
following new entry's:
If you see this or a similar information the device is installed correctly.
© Copyright 2021 by EXSYS Vertriebs GmbH. All Rights Reserved
4. Hardware Installation
Because there are large differences between PC
’
s, we can give you only a general installation
guide. Please refer your computer
’
s reference manual whenever in doubt.
1.
Connect the USB 3.2 Gen 1 cable to the USB B
-
Port at the Hub.
2.
Connect the included power supply to the DC connector at the hub or connect the optional
power supply into the terminal block at the Hub.
3.
Now connect the other end from the USB 3.2 Gen 1 cable (A
-
Plug) to the USB A
-
Port at your
PC.
6. Cleaning
For cleaning please use only a dry fluff less cloth and remove the dirt with gently pressure. In the
area of the connectors please make sure that no fibres from the cloth remain in the connectors.
Attention! Never use a moist or wet cloth for cleaning!
