2
3
How To Use
4
5
Turn the VOLUME ADJUSTER KNOB all the way clockwise until it stops.
Hold the metal detector so that the SEARCH COIL is held up in the air,
away from any metal objects.
To help your metal detector work at its very
best you will need to follow a procedure
called CALIBRATION. Please do the
following:
Turn the SENSITIVITY knob all the way
counter-clockwise. It will make a loud
beeping noise. Then turn the knob
clockwise very slowly until the tone stops.
STOP TURNING the knob the moment the
beeping stops. This position is the most
sensitive detection setting. You may want to
repeat this procedure a few times to ensure that you
have adjusted the metal detector to its optimum, most sensitive
calibration setting.
Move the metal detector close to a metal object and you will hear the
beeping tone. If you need to alter the sound, use the VOLUME
ADJUSTER knob to reach a comfortable noise level.
Now, swing the metal detector back and forth while keeping the search
coil level about 2cm above the ground. Move the search coil slowly. If you
move too fast you may miss an object. A series of five white LED lights
will display in the shaft.
When the metal detector detects a metal object, it will make a rapid
beeping noise, the LED lights will change from white to blue, and they
will flash more quickly.
Make sure that the
shaft, handle and
locking ring are
separated. (Fig. 1).
Place the locking ring
loosely on the shaft.
Insert the shaft into
the handle until it
stops (Fig. 2).
Turn the locking ring
anti-clockwise until
tight to lock the
handle in position
(Fig. 3).
Assembly
1
