3
Short manual
3.1
Switching On and Off
The device can be switched on and of by use of the integrated key switch.
3.2
Status display during startup
When switching on the device, the green status LED gives feedback over the battery
status of the device.
Batterystatus-LED (directly after startup)
3x Flashing
Battery is fully charged.
2x Flashing
Battery is not fully charged, but ready for use.
1x Flashing
Battery is discharged, and must be charged before the device is
being used again.
Batterystatus-LED during use
Continuous Flashing
Battery is discharged, and must be charged before the device is
being used again.
3.3
Manual ignition of the Flame effect
To prevent the effect from being triggered by mistake, two ignition buttons have been
integrated into the grips.
When you wish to use the effect, both buttons must be pressed at the same time. If
one of the buttons is pressed, the red status LEDs will start flashing. If the second
button is also pressed, the effect will be activated.
4
Important Safety functions
Next tot he two buttons needed fort he manual ignition, othe saftey features have
been integrated into the device.
Ifo ne of the two buttons is being pressed during startup,the red LEDs will start to
flash rapidly, and the device will not start correctly. Only if both buttons are not
pressed, the device will start.
During use, the red status-LEDs will flash shortly every four seconds. This is meant
to remind the user that the device is still activated.