1. Please hang a 20lb LP gas cylinder on the hook of
the gas cylinder on the right side of the oven, and
fasten it with the gas cylinder strap (Fig.2).
2. Check the cylinder valve to ensure it has proper
external mating threads to fit the hose and regulator
assembly provided.
3. Make sure all burner valves are in OFF position.
4. Inspect the valve connection port and regulator
assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use
damaged or plugged equipment.
5. When connecting regulator and hose assembly to
cylinder valve hand tighten quick coupling nut
clockwise to a full stop (Fig.1). Do not use a wrench
to tighten because it could damage the quick
coupling nut and result in a hazardous condition.
6. Open cylinder valve fully (counterclockwise). Use
a soapy water solution to check all connections for
leaks before attempting to light your grill. If a leak is
found, turn cylinder valve off and do not use your grill
until the leak is repaired.
CAUTION: When the appliance is not in use, gas
must be turned off at the supply cylinder.
Regulator Connection
Figure 1
Congratulations
Your gas grill is now ready for use. Before the
first use and at the beginning of each season
(and whenever the LP gas cylinder has been
changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according to
instructions found on next page of the manual.
Remove the gas cylinder from the grill
1. Make sure that the cylinder valve is in the closed position.
2. Make sure that all burner valves are in the closed position.
3. Open the cylinder strap.
4. When removing the regulator and hose assembly from the cylinder valve, loosen the quick
connection nut counterclockwise by hand, do not tighten it with a wrench, as this may damage the
quick connection nut and cause a dangerous situation.
Figure 2
20
Connecting LP Gas cylinder to LP Grill
