18
MB1 User Manual
© 2016 Expert Electronics
CONNECTIONS
Line-I n input .
MI C 1 input on the front panel of the transceiver can be used as a line-in input.
To connect line-in only use a monophonic 6.3 mm Jack Plug.
2.4.2
Headphones
Connect headphones to the PHONES jack. You can use headphones with an impedance from
8 to 64 Ohm or active speakers.
To connect headphones use st ereo 6.3 mm Jack Plug.
Warning!
i
Never use headphones wit h a mono connect or! I f you have monophonic
headphones, use st ereo 6.3 mm Jack and connect t hem t o one of t he channels.
i
Never connect t wo st ereo channels t o each ot her!
Note:
(
When you connect headphones
to the transceiver,
the internal speaker will continue to
operate. To disable it, go to a sound's local panel and turn off the speaker with SPEAKER
).
(
Headphones with high impedance may sound quieter.
2.4.3
USB Devices
You can connect any standard USB device with current consumption of up to 500 mA to the
USB connectors.
e.g.: flashcards, mouse and keyboard, wireless mouse and / or keyboard, WLAN adapters etc.
Note:
(
After connection of the USB device, it may take some time to search and automatically install
the drivers for the new device. After installation, the OS will begin to work with the USB device
in regular mode.
(
In some cases, it may be required, to search for drivers over the Internet and / or use manual
installation.
(
Older USB devices may not be supported
by the Windows 10 Home x64. Read the
Instructions for your USD device to make sure that it is supported by the Windows 10 Home
x64 OS.
56
