INSTALLATION FOR PCMCIA INTERFACE (OPTIONAL)
NOTE:
The PC Card interface is sold separately as an option component
for the CD ReWriter. Please contact EXP, if you wish to purchase
the PC Card.
HARDWARE INSTALLATION
If install on a NT station, make sure you turn OFF all power to your system
before connecting the CD ReWriter to your computer. However, you are
allowed to install the CD with power while using Windows 95/98, because
OS support plug-and-play.
1.
Connect the PCMCIA interface card to the CD ReWriter drive.
Push firmly until the CD-RW connector is seated, and then tighten
the two screws on the cable connector.
2.
Place the CD drive in the horizontal position.
3.
Consult your computer’s documentation to locate the PCMCIA
slot.
4.
Align the PCMCIA interface card with the arrow sign pointing to
the computer’s slot. (Please note that the card is keyed to guide
for proper orientation.)
5.
Slowly insert the PCMCIA interface card into the slot and press
firmly until the card is seated.
6.
You are now ready to install the CD ReWriter device driver.
SOFTWARE INSTALLATION FOR WINDOWS 95/98
The “New Hardware Found” dialog box* will appear when you insert the CD
ReWriter card under Windows 95 for the
very first time.
Select “Driver from disk provided by hardware manufacturer” and click on
the OK button
.
Insert the CD ReWriter device driver disk into your floppy
drive.
(If the dialog box does not appear, please refer to the “Trouble Shooting” section.)
If a dialog box come up select the CD-ROM , then click OK.
* Your dialog box may be different from the one shown depending on your Windows 95 version
CAUTION
The CD drive and electronic components installed on the CD ReWriter are
very sensitive to damage from static electricity. Before handling the unit,
touch a grounded metal surface. DO NOT connect/disconnect the CD
ReWriter
unit
to/from the parallel cable when the system is in power-on state.
