03
04
EX-12A/EX-15A BARON SERIES
EX-12A/EX-15A BARON SERIES
4.1 REAR PANEL DESCRIPTION
3.1 REAR PANEL (1)
3.2 REAR PANEL (2)
1
2
3
4
5
6
7
8
9
1
、
SD SLOT
:
Insert an SD card to read data from it
2
、
MODE BUTTON
:
Press to change modes between playing FM,USB, MP3 and Bluetooth
3
、
PLAY/PAUSE BUTTON
:
Press this button to start or pause play
4
、
RECYCLE BUTTON:Single song recycle/all songs recycle
5
、
FOLDER FUNCTION:Press this button to enter FOLDER selection
6
、
PREVIOUS BUTTON
:
Press this button to go to the previous track. Press and hold to scan backwards
within tracks
7
、
NEXT BUTTON
:
Press this button to go to the next track. Press and hold to scan forwards within tracks
8
、
USB SLOT
:
You can play media files from a USB device by connecting the device to this slot
9
、
IR:Remote control receiver
1.VOLTAGE SELECTOR
This switch allows you to select the AC electric current in use in your region. It is very important that you
select the correct MAINS POWER voltage before plugging in the power cord. For 220-240 volts 50 Hz, push
the switch up. For 110-120 volts60 Hz, push the switch down. Voltage levels vary from country to country,
(even from city to city in certain countries). For example
,
North America uses a 110-120 volt,60HZ system,
while the European standard is 220-240 volt,50HZ
2.IEC SOCKET
Connect the supplied AC power cord here. Since Baron active speakers have built-in power amplifiers, you
must connect them to an AC power supply or you won't get any sound.
Note: lf you happen to leave the power cord behind at agig, don't worry.The 3-pin plug with ground pin is
readily available at most office and computer supply stores.
3. POWER SWITCH
To turn on the Baron active speaker set the power switch to the on (l) position. To turn the Performer off, set
4. SPEAKON JACK
Use a cable to plug into this jack to connect active and passive speakers.
5. LIGHT SWITCH
Press to turn on or off the seven-color light.
the switch to the off position (o). Make sure the volume control is turned down all the way before you turn the
power on or off.
8
、
INSTRUMENT JACK:Two 1/4inch jack inputs for connecting musical Instruments
9
、
AUX IN::Auxiliary TRS input connector
10
、
MIC IN:This connector can either take a 1/4inch Jack balanced or an XLR balanced cabled microphone
11:MIC IN:This connector can either take a 1/4inch Jack balanced or an XLR balanced cabled microphone
12
、
RCA LINE IN:RCA connectors for line signal input
13
、
5 BAND EQ CONTROL:Adjust the amount of each frequency component in the sound signal to obtain
the desired emphasis effect
14
、
EFF LEVEL:Control total reverb
15
、
MASTER VOLUME CONTROL:Adjust the total volume
16
、
XLR LINE OUT:RCA connectors for line signal output
1
、
VOLUME LEVEL 1
:
Control the volume of line
2
、
VOLUME LEVEL 2
:
Control the volume of line
3
、
VOLUME LEVEL 3
:
Control the volume of line
4
、
REVERB KONB :Control the reverberation of line
5
、
REVERB KONB :Control the reverberation of line
6
、
MP3 KONB :Controls the MP3 input volume
7
、
INSTRUMENT JACK:Two 1/4inch jack inputs for connecting
musical Instruments
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
3
4
5
EXOTON
EXOTON