3
The charger unit supplied has been chosen specifically for the
EXO2
battery packs.
No other charger
should be used. The use of any other charger unit is dangerous, may cause injury and will void the
warranty.
G
ETTING THE
B
EST
R
ESULTS
Although the battery has been charged and checked, we recommend
that you charge it for at least 3 hours prior to first use. The closer the
FabRoc™ panels are to your skin, the more heat you will feel. For
maximum benefit, wear only a fine pullover, t-shirt or blouse
underneath your StormRider bodywarmer.
Bodywarmers using an optional battery pack will provide heat for up to 3 hours of continuous use on
battery Level 5.
S
AFE
O
PERATIONS AND
S
AFETY
F
EATURES
The FabRoc™ heating system has been designed for safe and reliable use. It has been tested to comply
with US safety regulations and has been marked with the CE seal of approval. Safety devices are included
to ensure the unit is rendered safe, even under faulty conditions.
DO NOT
replace or interfere with the
electrical components in the StormRider Bodywarmer, the battery or the charger unit.
DO NOT attempt
to open the sealed battery unit.
Batteries should be discarded in accordance to local governmental
regulations.
C
LEANING
I
NSTRUCTIONS
Remove the batteries from your
StormRider Bodywarmer
. Hand wash the garment in warm water using any
commercial liquid soap product and rinse thoroughly. It is inadvisable to use fabric conditioner, biological
powders or strong detergents. DO NOT dry clean. It is recommended to drip or line dry the vest/jacket.
W
ARRANTY
Every StormRider Bodywarmer has a one-year warranty covering all electronic and mechanical failures. In
the unlikely event that any part should fail within the first year, return it to us and we will repair or replace
it free of charge.
Note: The warranty does not cover intentional alterations, accidental damage or
improper cleaning.
T
ROUBLESHOOTING
What happens if my StormRider Bodywarmer is torn?
1.
DO NOT
attempt to replace or interfere with the electrical components in the
StormRider
Bodywarmer
.
2.
Return the garment to EXO2 for repair.
What happens if my StormRider Bodywarmer does not get warm?
If powered by a 12v volt power unit battery, ensure that the 1,3mm rechargeable battery cable is plugged
into the 1.3mm socket (also in the pocket) to complete the four panel circuit. If using a portable,
rechargeable battery, confirm that the battery is properly charged (per the previously mentioned
instructions). If the red light on the charger comes on and stays on, and/or the LED on the battery reads
‘0’ or ‘1’, the battery needs to be recharged.
