Exo Terra Turtle Filter PT3630 Operating Instructions Manual Download Page 4

6

or maintenance. Pull the 4 cover locks outwards to unlock the filter 

cover. Pull upwards on filter cover to remove it from the pump 

section.

Impeller:

The impeller well, although it is self cleaning, requires regular 

maintenance to remove dirt, slime and debris build-up to ensure 

smooth running and to extend the life of the filter. The impeller and 

impeller well (where the impeller is located) should be cleaned at 

least once a month, more often if necessary.

To access the impeller, remove the pump chamber (located on the 

underside of the filter cover) by pulling downwards. Remove the 

impeller cover, and grasp the blades of the impeller to pull out the 

impeller. Rinse impeller under running water and use a brush if 

necessary to thoroughly clean the impeller and the impeller well to 

remove slime, dirt or debris. Place the impeller back into the impeller 

well. Replace the impeller cover, then re-attach the pump chamber.

Note:

If you have hard water, run the filter for a few minutes in a 50/50 

solution of water and vinegar to help remove calcium and mineral 

deposits before re-installing the filter on the tank.

Filtration Media:

Note

: It is not recommended to rinse the foam or other filter media 

directly in tap or well water, as the water contains chemicals that 

make it unsafe to reptiles and amphibians. As a precaution, the 

foam should always be rinsed in de-chlorinated water. To do this, 

fill a container with water and then treat the water with a water 

conditioner such as Exo Terra

®

 Aquatize to neutralize the chemicals. 

Once the water has been de-chlorinated, you can then rinse the 

foam. (note: this procedure is also recommended when replacing 

with new foam).

Filter media (foam, carbon pads and odor reducing resin pads) 

should be replaced every 6-8 weeks to ensure proper functioning 

of the filter, more often if necessary. Never rinse or replace all filter 

media at the same time, alternate rinsing/replacement of filter 

media.

Coarse Foam:

 Remove filtration basket “A” and slide off the top. 

Remove both of the course foam cartridges and rinse thoroughly 

until all dirt, sludge and waste is removed. Clean the filtration 

basket thoroughly with clean warm (not hot) water. Do NOT use any 

detergents or solvents! Replace the coarse foam cartridges back into 

position and slide the top back onto the filtration basket.

Replacement coarse foam cartridges can be obtained from your pet 

store or retailer (PT3636 Coarse Foam Cartridge).

Fine Foam

: Remove filtration basket “B and slide off the top. 

Remove the fine foam cartridge and rinse thoroughly until all dirt, 

sludge and waste is removed. Replace the washed fine foam 

cartridge back into position and slide the top back onto the filtration 

basket.

Replacement fine foam cartridges can be obtained from your pet 

store or retailer (PT3635 Fine Foam Cartridge). 

Dual Carbon Pads:

 Remove and rinse, or discard and replace with 

new carbon pads as necessary. Replacement carbon pads can be 

obtained from your pet store or retailer (PT3638 Dual Carbon Pads).

Odor Reducing Resin Pads:

 Remove and rinse, or discard and 

replace with new resin pads as necessary. Replacement odor 

reducing resin pads can be obtained from your pet store or dealer 

(PT3639 Resin Pads).

Clean the filtration basket thoroughly with clean warm (not hot) 

water. Do NOT use any detergents or solvents!

Replace the odor reducing resin pad back in the filtration basket.

Replace the dual carbon pads back in the filtration basket.

Clean the canister and the divider thoroughly with clean warm (not 

hot) water. Do NOT use any detergents or solvents!

Replace the filtration baskets A & B back into the canister.

Replace the filter cover on top of the pump section, ensure that the 

4 cover locks are in the“open” position (in outward position). Press 

down firmly to ensure the filter cover is seated on the pump section, 

and close the 4 covers locks until they click into position.

Open reservoir cap, and fill reservoir with clean water. Replace cap 

and rotate clock-wise until it locks.

Water Treatment:

 The water should be treated with Exo Terra

®

 

Aquatize Terrarium Water Conditioner (PT1976, sold separately) to 

remove chlorine and heavy metals. 

Tip:

 Adding Exo Terra

®

 Biotize Biological Waste Degrader (PT1986, 

sold separately) will help keep the water cleaner longer, provide 

optimal filtration results, and promote necessary beneficial bacteria 

and reduce odors associated with decaying waste.

GUARANTEE

This product is guaranteed for defects in material or workmanship 

for a period of 2 years from date of purchase. The guarantee is valid 

with proof of purchase only. The guarantee is limited to repair or 

replacement of the filter only and does not cover consequential loss

or damage of or to animate or inanimate objects. The warranty does 

not cover wear and tear parts such as the impeller. The warranty 

also does not cover any filter which has not been regularly and 

correctly cleaned and maintained. This guarantee is valid only 

under normal operating conditions for which the filter is intended. 

It excludes any damage caused by unreasonable use, improper 

installation, negligence, tampering, or abuse of the filter. The filter 

motor is factory sealed, tampering will void guarantee. For guarantee 

service contact your local pet retailer or write to the representative in 

your country. This guarantee does not affect your statutory rights.

ENGLISH

FRANÇAIS

ESP

AÑOL

Reviews: