- 14 -
FIGURE 1
SUPPORT PIN LOCATION
3.5.5
Mower Deck Stationary Idler Installation:
Locate the two holes along the back center section of the deck and install the
stationary idler and related parts (from bolt bag) in the right hand hole. See
Figure 2. Be sure the coned end of the disc spring washer is against the head of
the bolt. Tighten hardware.
FIGURE 2
STATIONARY IDLER INSTALLATION
3.5.6
Install the deck drive belt around the clutch. Refer to belt routing decal. Be sure
belt is in the clutch drive sheave groove. Place the other end of the belt into the
V-groove of the stationary idler, move the spring loaded idler outward and route
the belt around the inside of the spring loaded idler. Position the belt into the V-
groove of the mower deck drive sheave.
Carefully
release the spring loaded
idler. Install the center belt shield.
3.5.7
Adjust cutting height of deck and anti-scalp rollers. See Adjustment Section 5.2.1.
3.6 POSITION DISCHARGE CHUTE:
Loosen two (2) 5/16” nyloc nuts attaching discharge chute. Lower the discharge
chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.
3.7 SERVICE ENGINE:
See Engine Operator's Manual.
3.8 SERVICE HYDRAULIC OIL
The machine is shipped with hydraulic oil in the reservoir. Run the machine for
approximately 15 minutes to allow any extra air to purge out of the hydraulic
system. Check hydraulic reservoir and if necessary fill the reservoir to the
appropriate level with Mobil 1 15W-50 synthetic motor oil. Replace hydraulic
reservoir cap and tighten until snug.
Do not overtighten.
3/8-16 x 4 1/2
HEX CAPSCREW
