Maintenance
in solvent if necessary). Reinstall arrester on
exhaust outlet.
Thread Locking Adhesives
Thread locking adhesives such as “Loctite 242”
or “Fel-Pro, Pro-Lock Nut Type” are used on the
following fasteners:
•
Pump pulley setscrews.
•
Pulley retaining bolt in end of engine PTO.
•
Clutch retaining bolt in end of crank.
•
Caster wheel spacer nuts.
•
Platform suspension pivot shaft.
Mobil HTS Grease (Or
Food-Grade Anti-seize)
Mobil HTS grease (or food-grade anti-seize) is used
in the following locations:
Between splines of the cutter housing spindle and
sheave.
Copper-Based Anti-seize
Copper-based anti-seize is used in the following
locations:
•
On threads of Blade Bolts. See
Check Mower
Blades
section.
•
Between engine crankshaft, PTO shaft, and PTO
pulley.
•
Between pump shafts and pulleys.
Dielectric Grease
Dielectric grease is used on all blade type electrical
connections to prevent corrosion and loss of contact.
Dielectric grease should not be applied to sealed
connectors.
Adjustments
Note:
Disengage PTO, shut off engine, wait for
all moving parts to stop, engage parking brake, and
remove key before servicing, cleaning, or making any
adjustments to the unit.
Deck Leveling
1.
Position the mower on a flat surface.
2.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
3.
Check the tire pressure in drive tires and
pneumatic front caster tires (if equipped). Proper
inflation pressure for tires is 13 psi (90 kPa).
Adjust if necessary.
4.
Pull the deck lift handle all the way rearward to
latch the cutting deck into the raised transport
position.
5.
Insert the height adjustment pin into the 3 inch
(7.6 cm) cutting height location.
6.
Release the transport lock and allow the deck to
lower to the cutting height.
7.
Raise the discharge deflector.
8.
Measure from the level surface to the front tip of
the center blade. The measurement should read
3 inches (7.6 cm).
Note:
In most conditions, the back tips on the
side blades should be adjusted 1/4 inch (6.4 mm)
higher than the front.
39
Summary of Contents for STARIS S Series
