Operation
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Controls
Note:
Become familiar with all the controls before
starting the engine and operating the machine.
Motion Control Levers
The motion control levers, located on each side of the
top console, control the forward and reverse motion
of the machine.
Moving the levers forward or backward turns
the wheel on the same side forward or reverse
respectively. Wheel speed is proportional to the
amount the lever is moved.
Moving the levers outward, from the center position
into the notch, locks them in the neutral position
(see Figure 4).
g224633
Figure 4
1.
Neutral lock position
(handles out)
5.
Rear reference bar
2.
Neutral operate position
(handles in)
6.
Front reference/Speed
control bar
3.
Front of machine
7.
Forward
4.
Reverse
8.
Adjustment hole
Note:
When the motion control levers are in the
neutral lock position, a LCD indicator displays on
the message display.
Note:
When the motion control levers are moved
inward, a LCD indicator appears in the operator
presence of the message display.
Choke Control (All Models Except
Kohler EFI)
Located on the LH side of the control console (black
lever) (see Figure 5).
The choke is used to aid in starting a cold engine.
Moving the choke lever forward will put the choke in
the “ON” position and moving the choke lever to the
rear, to the detent, will put the choke in the “OFF”
position. Do Not run a warm engine with choke in
the “ON” position.
g268307
Figure 5
Non-EFI Model Shown
1.
Choke
6.
Front Reference/Speed
Control Bar
2.
Throttle
7.
RH Motion control lever
3.
Rear reference bar
8.
PTO engagement switch
4.
LH Motion control lever
9.
Ignition
5.
Message display
Throttle Control
Located on the LH side of the control console (red
lever).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Park Brake Lever
Locate on the left side of the machine.
The brake lever engages a parking brake on the drive
wheels.
15
Summary of Contents for STARIS S Series
