Operation
Figure 5
1.
Tine down pressure
gauge
7.
RH Motion control lever
2.
Tine down pressure
control
8.
Hour meter
3.
LH Motion control lever
9.
Park brake
4.
Front reference bar
10.
Ignition switch
5.
Throttle
11.
Tine ground engagement
foot switch
6.
Choke
Throttle Control
Located on the control console (red lever) (see
Figure 5).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Park Brake Handle
Located on the right side of the ignition switch on
the control console (see Figure 5).
The brake handle engages a parking brake in the
transmissions.
To engage the brake, pull handle out and slide
rearward.
To release, push the handle forward into the detent.
When parking on a steep slope, the wheels must be
chocked or blocked in addition to the brake being
engaged. The unit must be tied down and brake
engaged when transporting.
Ignition Switch
Located on the right side of the control console (see
Figure 5).
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”, “ON”
and “START”. Insert key into switch and rotate
clockwise to the “ON” position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position). Allow
the key to return to the “ON” position immediately
after the engine starts.
Figure 6
1.
Off
3.
Start
2.
On
Note:
To start the engine, the parking brake must
be engaged. (It is not necessary for the operator to
be on the platform.)
Hour Meter
Located above the ignition switch (see Figure 5).
The hour meter displays the number of hours of
operation that have been logged on the machine.
Fuel Shut-Off Valve
Located under the fuel tank.
The fuel shut-off valve is used to shut off the fuel
when the machine will not be used for a few days,
during transport to and from the jobsite, and when
parked inside a building.
Align valve handle with the fuel line to open. Rotate
90° to close.
16
Summary of Contents for SAR481KA30
