Page 10 of 13
109-4232 Rev. A
Align Dimple Here
Align Dimple Here
33. Install the belt (Item 13) onto the blower by
working it around the impeller sheave.
FIGURE 14
All units
:
34. Mount the blower on the deck by sliding the
mounting pin into the tube at the rear right corner
of the deck. Swing the blower closed. Adjust the
position of the front pin to engage the slot in the
front of the deck. Use the latch to lock the blower
in this position. Adjust the tension on the latch to
hold the blower up to the deck, yet allow for
release by hand.
35. Pull the spring loaded idler back and slip the belt
over the top deck spindle sheave.
36. Install the plastic belt cover (Item 10). On 60”
and 66” units the outside end of the cover is
slotted and can slip between the two washers
assembled in step 31. The plastic knob does not
need to be removed. On 72” and 52” units the
cover has a hole, and the plastic knob must be
installed after the cover has been positioned.
The
original belt cover stud must be removed on
52” units.
On Units SN 600,000 and Higher with Triton
decks
:
37. Adjust dog leg baffle to match Ultra Vac blower
intake opening. Adjusting too wide may allow
objects to be thrown from under the mower deck
at high speed. Adjusting too narrow may cause
plugging issues.
WARNING
POTENTIAL HAZARD
♦
If the blower intake opening is not correct it
will allow objects to be thrown in operator’s or
bystander’s direction. Also, contact with blade
could occur.
WHAT CAN HAPPEN
♦
Thrown objects or blade contact can cause
serious injury or kill you or bystanders.
HOW TO AVOID THE HAZARD
♦
Adjust dog leg baffle to match intake opening.
Assemble the Tubes
1. Slip upper and lower tubes together.
2. Insert upper tube into hopper seal – push in
then pull out so that seal is extended outward.
Align dimple on upper tube with end of hopper
seal and position vertically between the two
screws as shown in Figure 15.
52” UNITS
60”, 66” & 72” UNITS
FIGURE 15
RELEASED Version ©Toro 2006-2007