7
•
Check carefully for overhead clearances (i.e. branches, doorways, and
electrical wires) before driving under any objects and do not contact them.
1.4.6 Use
EXTREME
caution when backing up.
LOOK BEHIND YOU!
1.4.7
Stop the blades when crossing surfaces other than grass and when transporting
the mower to and from the area to be mowed.
1.4.8
Never operate the mower with damaged guards, shields, or covers. Always have
safety shields, guards, switches, and other devices in place and in proper
working condition.
1.4.9
DO NOT
change the engine governor settings or overspeed the engine.
Operating an engine at excessive speed may increase the hazard of personal
injury.
1.4.10
Disengage PTO before starting engine.
1.4.11 Start
the
engine
carefully
with
feet
well
away
from
the
blades.
1.4.12
Keep hands, feet, and clothing away from rotating parts while the mower is being
operated.
1.4.13
Stop engine, wait for all moving parts to stop, and remove key:
•
Before checking, cleaning or working on the mower.
•
After striking a foreign object (inspect the mower for damage and make
repairs before restarting and operating the mower).
•
Before clearing blockages.
•
Whenever you leave the mower.
Stop the engine and wait for all moving parts to stop:
•
Before
refueling.
•
Before dumping the grass catcher.
1.4.14
Before stopping the engine, place the throttle control
midway
between the “slow”
and “fast” positions. Allow the engine to run a minimum of 15 seconds; then stop
the engine.
1.4.15
The fuel system is provided with a shut-off valve. Shut off the fuel:
•
When the machine will not be used for a few days.
•
During transport to and from the job.
•
When parked inside a building.
1.4.16
This mower was designed for one operator only. Keep all others away from
mower during operation.
1.4.17
Do Not
mow with the discharge deflector raised, removed or altered unless there
is a grass collection system or mulch kit in place and working properly.
1.4.18
Be aware of the mower discharge and direct discharge away from others.
1.4.19
Do Not
operate mower under the influence of alcohol or drugs.
1.4.20
Use extra care when approaching blind corners, shrubs, trees, or other objects
that may obscure vision.
1.4.21
If jump starting is required:
a) connect the positive (+) power cable from the positive post on the booster
battery to the positive terminal post on the starter solenoid switch (this post
has the positive battery cable attached to it).
b) connect the negative or ground cable (-) from the negative post on the
booster battery to the engine block as far away from the battery as possible.
c) disconnect battery cables in the reverse order after starting.
Summary of Contents for LAZER Z ADVANTAGE SERIES
