© 2013 Exile Audio • www.exileaudio.com
Amplifier Manual
2 Channel Power Amplifier
XM30.2
OUTPUT
Connect preamp signal cables from the head unit to
these terminals.
INPUT
Connect preamp signal cables from the head unit to
this terminal.
HPF
Controls the high pass crossover point for the
speaker outputs.
XOVER
HF - Sends high frequency signal to speakers.
FULL - Sends a full range signal to speakers.
LF - Sends low frequency signal to subwoofer.
LPF
Controls the low pass crossover point for the
speaker outputs.
BASS BOOST
Variable bass boost from 0 to +18dB @ 45 Hz.
GAIN
Used to reach maximum amplifier power with a wide
variety of headunits.
POWER/PROTECT
Indicates if the amplifier is working correctly (BLUE) or gone into
protect mode (RED).
SPEAKER OUTPUTS
Used to connect the amplifier to the speakers. Use the
left channel positive (+) and the right channel negative (-) for
bridged mode.
FUSE
This amplifier requires two 40A fuses.
12V+
This must be connected to the fused positive terminal (+12V) of
the car’s battery.
REMOTE
This must be connected to sw12V, usually a trigger wire
coming from the head unit or ignition.
GND
This must be connected to the negative terminal of the car’s
battery or bolted to a clean, unpainted part of the chassis of
the vehicle.
tower speakers
4ohm
2ohm
2ohm
Cabin
Amplifier
Subwoofer
Amplifier
Tower
Amplifier
cabin speakers
subwoofer
Stereo
Battery
Starting
Battery
Perko
Battery
Selector
Switch
ANL Fuse
Holder
2
2
1
1
L
R
L
R
R
L
1/0 ga.
4 ga.
Ground
Distribution
Block
MANL Fused
Power
Distribution
Block
Input
Input
Input:
Source Unit
ZLD
zoned line driver
Aux Input:
phone/
mp3 player
R
L
R
L
L
R
L
R
XMRB1 Bass Control
1
11
SWITCH
L
R
Input