EXFO T200S, User Manual, Page: 86 / 146

SCPI Command Reference
80
T200S
T200S Specific Commands
T200S Specific Commands
Quick Reference
The table below contains a summary of the T200S specific commands. These commands
are fully explained on the following pages.
Command/Query
category
Corresponding section
:ABORt ABORt on page 80
:ARM ARM Commands and Queries on page 81
:CALibration CALibration Commands and Queries on page 83
:FORMat FORMat Commands and Queries on page 87
:INITiate INITiate Commands and Queries on page 89
:MEASure MEASURE Commands and Queries on page 90
:OUTPut OUTPut Commands and Queries on page 92
[:SOURCE] SOURce Commands and Queries on page 96
:STATus STATus Commands and Queries on page 126
:SYSTem SYSTem Commands and Queries on page 128
:TRIGger TRIGger Commands and Queries on page 133
:UNIT UNIT Commands and Queries on page 135
ABORt
Description This command resets the trigger system and places all trigger
sequences in the idle state. The command is not completed until
the trigger sequence is in the idle state.
This command aborts any sweep in progress.
This command is an event and has no associated *RST condition
or query form.
Syntax
:ABORt
Parameter(s) None.
Example(s) ABOR
See Also INITiate[:IMMediate][:ALL] on page 89
:STATus:OPERation:CONDition? on page 126