EXFO T200S, User Manual, Page: 101 / 146

SCPI Command Reference
Tunable Laser Source
95
T200S Specific Commands
OUTPut:SYNChronization[:STATe]
Description
This command controls the activation of the output signal
generation on the Trig out BNC connector located on the rear
panel.
At *RST, this value is set to OFF.
Syntax :OUTPut:SYNChronization[:STATe]<wsp><state>
Parameter(s)
state :
State of the Trig out output. The allowed values are:
³
OFF|0 (default): the output is closed, which means that no
signal is output from the BNC port.
³
ON|1: the output is open.
Example(s) OUTP:SYNC:STAT OFF (closed)
See Also
OUTPut:MONitor1|2[:STATe]
on page 93
OUTPut:SYNChronization[:STATe]? on page 95
OUTPut:SYNChronization[:STATe]?
Description This query indicates if the output signal generation is active for the
Trig out BNC connector located on the rear panel.
At *RST, this value is set to OFF.
Syntax :OUTPut:SYNChronization[:STATe]?
Parameter(s) None.
Response Syntax <state>
Response(s) state:
State of the Trig out output:
³
0 (default): the output is closed, which means that no signal is
output from the BNC port.
³
1: the output is open.
Example(s) OUTP:SYNC ON
OUTP:SYNC? returns 1 (open)
See Also OUTPut:MONitor1|2[:STATe]? on page 94
OUTPut:SYNChronization[:STATe] on page 95