EXFO Power Blazer 88200NGE, User Manual

Page: 235 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
225
Interface
For EtherBERT test application:

Remote Fault Emulation
check box when selected, generates
Remote
Fault ordered sets when a Link Fault is received. Only available with
EtherBERT, 10GE (all framing at the exception of
Seed A/B
and
PRBS31
Unscrambled ), and 40GE/100GE ( Framed Layer 2 and up).
For Ethernet and Packet Sync test applications:

For optical interfaces, the Local Fault Detected , Local Fault Received ,
Remote Fault
,
LOA
,
Hi-BER
, and/or
WIS Link
(10GE WAN) alarm
status are displayed. Refer to Ethernet on page 405 and Ethernet - PCS
Lanes
on page 410 for more information.

Auto-Negotiation check box is available with 10/100/1000M Electrical
and
1GE Optical
interfaces. When the
Auto-Negotiation
check box is
selected the test application indicates to the remote port which
parameters to use. The
Auto-Negotiation
check box is automatically
selected (not configurable) for 1GE Electrical interface and when using
an active copper SFP.
Note: When the Auto-Negotiation check box is selected, the port Speed , Duplex ,
Flow Control , and Local Clock parameters can be set. Those settings are
not applied immediately to the port, they are used only when the
negotiation process is started and take effect only when the
auto-negotiation succeeds. However current settings are applied
immediately to the port when the
Auto-Negotiation check box is cleared.