EXFO Power Blazer 88200NGE, User Manual

Page: 233 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
223
Interface
Interface
From the
Test
menu, tap
Setup
,
Test Configurator
, the interface block,
and the Interface tab.
Port, FlexO Instance ID, and FlexE PHY Number
Note:
Only available with FlexE/FlexO BERT test application.

Port
allows selecting the physical port to be displayed.

FlexO Instance ID indicates and allows changing the FlexO Instance
ID (
1
to
254
) assigned to the port.

FlexE PHY Number indicates and allows changing the FlexE PHY
number (
1
to
254
) assigned to the port.
LINK
An arrow is used to indicate the port link status (at the PCS level for parallel
interfaces): link up (green arrow), error or link down (red arrow), or
awaiting incoming data to provide a status (gray arrow).
Note: Refer to Ethernet on page 405 , Fibre Channel on page 413 , Ethernet - PCS
on page 408
, and PHY
on page 448
for more information on alarms.
For 25GE framed Ethernet interface:
RS-FEC
check box when selected (default) enables the use of RS-FEC.
For 100GE (4 Lanes) framed Ethernet interface:

RS-FEC
check box when selected (default), enables the use of the
RS-FEC; ensure both ends of the circuit have the FEC enabled. The
RS-FEC
check box should be selected when using a 100GBASE-SR4,
100G-CWDM4, or 100G AOC transceiver but may be cleared for testing
purposes. Not available when the
PHY Type
is set to
LR4/ER4
(see
page 132).