EtherSAM Tabs
336
IQS-8500 Series and IQS-8120NGE/8130NGE
Services (Configuration)
Test Parameters
Ramp Traffic Policing Rate
allows to stress the rate limiting of the network
by sending traffic at higher rate than committed by the SLA. The
Ramp
Traffic Policing Rate
check box is selected by default.
Burst Max Rate
allows to set the rate that will be used for the CBS and EBS
burst tests.
Burst Max Rate
is only available when the
Burst Test
is
enabled; see
Note:
Changing a criteria value (CIR, CIR+EIR, Ramp Traffic Policing, or Burst
Max Rate) may affect the other criteria values in order to comply to the
following rules:
CIR
CIR+EIR
Ramp Traffic Policing Rate
Line Rate
CIR
CIR+EIR
Burst Max Rate
Line Rate
However, make sure that the criteria values comply to the following rule
with an adequate margin, as per ITU-T Y.1564 standard, for a burst test to
be valid:
CIR
CIR+EIR
Burst Max Rate
Line Rate
