EXFO FTB-860, User Manual

Page: 63 / 409

EtherSAM Test Setup and Results
NetBlazer
51
Service Profile Configuration

Overshoot allows to stress the rate limiting of the network by sending
traffic at higher rate than committed by the SLA.
Note: The CIR, EIR, and Overshoot values must comply to the following rule:
CIR
 
EIR

Overshoot

Line Rate when the EIR check box is selected, or to
CIR

Overshoot

Line Rate when the EIR check box is not selected.
Entering a CIR, EIR, or Overshoot value may affect the other values in order
to respect this rule.

Total TX Rate (Mbit/s)
: The
Total TX Rate
presents the sum of the
transmit rate of all services enabled for transmission.
Note:
Number of services enabled at the same time depends on total transmit
rate (CIR of the respective enabled services) and the total transmit rate of
all enabled service should be less than or equal to 100 % of the line rate.

Max Jitter (ms) : Select the Max Jitter check box and enter the
maximum jitter value. If the average jitter value is greater than
Max
Jitter value, the test will fail. The accepted range is from 0.015 to 8000
milliseconds. The default value is
2.0
.

% Frame Loss : Select the % Frame Loss and enter the frame loss
percentage. If the determined frame loss value for a specific frame size
is greater than the value set in
% Frame Loss field, the test will fail. The
accepted range is from
0
to
5
. The default value is
0.1
.

Round-trip Latency (ms) : Select the Round-trip Latency check box
and enter the round-trip latency value. If the round-trip latency value is
greater than value specified in the
Round-trip Latency field, the test
will fail. The accepted range is from
0.015
to
8000
milliseconds. The
default value is 1 5.0 .