EXFO FTB-860, User Manual

Page: 322 / 409

Common Test Setup, Results, and Functions
310
FTB-860/880
MAC/IP/UDP Configuration
Configure the IPv4 Parameters

DHCP : Select Enabled or Disabled to enable or disable the DHCP.
Note: If
DHCP
is enabled, all parameters are set to the values obtained through
DHCP.
Note: If
DHCP
is disabled,
IP Address
and
Subnet Mask
fields become
configurable. When DHCP is enabled, the Default Gateway is
automatically obtained from DHCP.

The DHCP Server Address displays the DHCP server IP address when
DHCP is enabled.

The DHCP Lease Obtained displays the date and time that the IP
address was leased from the DHCP server when DHCP is enabled.

The DHCP Lease Expires displays the date and time that the IP
address lease will expire when DHCP is enabled.

Configure the IP Address : The default IP address is 10.10.0.0 . When
the IP Address field is selected for editing using virtual keyboard, the
Previous IP Addresses button appears on the screen. Press the
corresponding function key to display the list of previously configured
IP addresses. Select the desired IP address from the list, if any.

If DHCP is disabled, enter the
Subnet Mask
for the Ethernet port. The
default value is 255.255.0.0 .

Enable or disable the
Default Gateway
from
Mode
. The default setting
is Disabled .

If Default Gateway Mode is enabled, enter the Default Gateway
Address for the Ethernet port. The default value is 0.0.0.0 .
Configure the IPv6 Parameters
If
IPv6
option is selected as the IP version, in the
Network
page, configure
the remaining fields as below.